EC/TDS Sensor
EC/TDS Sensor
WTE1007_HT Series
Features
- Automatic temperature compensation
- Temperature up to 120 Deg.Cel.
- Low Maintenance - Reduced cleaning requirements
- Range of cell constants
With the ability to detect conductivity, EC, and TDS, the WTE1007 performs a number of tasks simultaneously. Its cost-effective integrated design supports boiler water, RO water treatment, sewage treatment, the pharmaceutical industry, and other liquid measurement and monitoring.
EC/TDS Sensor Calibration
Rinse the Sensor: Use distilled water to clean the sensor before calibration.
Immerse in Calibration Solution: Place the sensor in a standard conductivity solution with a known value (e.g., 1413 µS/cm).
Adjust the Meter: If the meter reading doesn’t match the solution’s conductivity, adjust the meter or follow the device-specific calibration procedure.
Rinse and Repeat: Rinse the sensor, then repeat the process with another standard solution if multiple calibration points are required.
Confirm Calibration: Verify the sensor’s accuracy by checking it in a fresh calibration solution.
Technical Specification
Product
TDS sensor, EC sensor, Resistivity sensor
Model
WTE1007_HT Series
Measure range
0.01 electrode: 0.01~20us/cm
0.1 electrode: 0.1~200us/cm
1.0 electrode: 1~2000us/cm
Accuracy
±1%FS
Thread
G3/4
Pressure resistance
0.8MPa
Material
stainless steel (SS304/ SS316)
Temp compensation
NTC10K (PT1000, PT100, NTC2.252K optional)
Temperature range
0-60℃
Temperature accuracy
±3℃
Ingress protection
IP68
Temperaure Compentation range
0-100℃, 0-120℃
Cable
05 Meter , 10 Meter
Sensors
Features
Measurement accuracy: 1%
Temperature resistance range: 0~50
steel electrode); 0~50 (4-electrode)
Temperature accuracy: 1 Deg.Cel
Temperature compensation: NTC10K
(optional Pt100,PT1000, NTC2.252K)
Pressure range: 5bar(constant 0.01 / 0.1)
7bar(constant1.0)( SS electrode); 5bar (4-
electrode)
Housing material: SS 316 or SS 304
steel electrode); PBT (4-electrode)
Process connection: G3/4 threaded
installation steel electrode); NPT3/4
threaded installation(4-electrode)
Ingress protection: Ip68
The Model EEC110 sensor was designed for high pressure, high temperature conductivity measurements, and is an ideal choice for boiler control applications. Blowdown control, condensate monitoring, leak detection on heat exchangers, and steam purity measurements are just a few of the many applications in which this rugged and reliable sensor can be used. Weed materials of construction are 316 stainless steel, PEEK, and EPDM Orting’s. All possible leak paths through the sensor are double sealed with orienting’s for maximum on-stream reliability. Hot water is a severe environment for any elastomer, and the front seals bear the brunt of chemical a attach, allowing the back seals to remain relatively unaffected. The result is that sensor Life The device is designed for use on site. A rugged housing protects the electronics and the electrical connections from corrosive environmental conditions . As an alternative, the device can also be installed in a control panel.